Re: [libreoffice-users] the table starts everytime in a new page - after I type the heading for the table

Hello, 

On Fri, 4 Feb 2011 02:23:48 -0800 (PST)
sivakumar <calmsiva@gmail.com> wrote:

> I have been using OOO 3.2, and now have installed libre office 3.3,
> yesterday.
>
> In both I have noticed the following :
>
> - whenever I tried making a table (mainly for tender
> specification-cum-compliance) wherein I create a table with say 3 to 4
> coloums, and tried cutting & pasting in each cell, the table starts in a new
> page.

When you copy & paste, try to insert as "text only". I think, this can be achieved by using 
CTRL+Shift+V instead of STRL+V. 

You could also check the properties of the table. To do this, move your cursor into the table and 
the table toolbar appears. There's an icon called "Table properties" (a table with a small hammer, 
the 3rd icon from the right in the second row in my installation). Go to the register "Text flow" 
and check, if there is a checkmark for "Break". It's the very first entry on this tab. If there is, 
just remove it and your table should appear again on the previous page when you close the dialog. 

 
> - this is happening always with both the OOO & LO3.3
>
> - I will usually have 3 or 4 lines - which contains the headings and after
> than I create a table.  Every time in this page - only the headings will be
> there.  The table gets to the next page, leaving the first page fully blank
> - only with the headings.
>
> What should I do for making the table which was created - just after the
> headings - to stay there only.
>
> please help.

I hope, that the above description will help you sort your problem out. If it doesn't work, then 
please come back and describe what you did. 

Sigrid

-- 
Unsubscribe instructions: E-mail to users+help@libreoffice.org
List archive: http://listarchives.libreoffice.org/www/users/
*** All posts to this list are publicly archived for eternity ***